An Arduino-based cnc controller for separate stepper drivers? grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board.

Later, I helped a friend disassemble a Tesla model, and the mass of circuit boards inside was overwhelming—until I drew 5 ...

This machine uses a three-phase Dahlander motor, which has three operation modes: stop, half speed, and full speed. The motor uses a special mechanical switch to select the operating mode.

TheMIDInator MIDI controller has been created by Switch & Lever using an Arduino Mega with its 54 digital IO and 16 analog pins to provide a wealth of ...

After purchasing the Qu4tro electric skateboard and finding the controller wasn’t quite as good as the skateboard, Timo Brinschein decided to build his very own using a little Arduino hardware ...

As the valves use 24V and the motor 12V, standard N-Mosfets and power relays are used for voltage conversion. The remote controller [Gilard] used is actually 20 years old, so the output signal of ...